Resmed Airfit N10 Cushion
Resmed Airfit N10 cushion only.
Purchase is for 1 x cushion for the Resmed N10 nasal mask. Not compatible with the Resmed N20 nasal mask.
Available in Small, Standard and Wide.
N10 sizing and fitting guide is available on the Resmed website
Resmed Airfit N10 Cushion only. You need to replace your cushion occasionally as it becomes soft or loses its elasticity as a result this leads to air leaks, over-tightening and discomfort. It is recommended to replace the cushion every 12 months.
Purchase is for 1 x cushion for the Resmed N10 nasal mask. Available in Small, Standard and Wide.
N10 sizing and fitting guide is available on the Resmed website or please use attached sizing template https://www.resmed.com/au/dam/documents/products/Mask/airfit-n10/fitting-template/1017456r2_airfit-n10_fitting-template_row_eng.pdf
Please note this Resmed Airfit N10 cushion is not compatible with the Resmed N20 nasal mask.
Resmed recommends to wash the cushion daily. It’s best to handwash the cushion by gently rubbing it in warm (approximately 30°C) water using mild soap. Then rinse well with drinking quality water and air dry.
The AirFit N10 raises the bar for ResMed’s compact nasal masks. Made up of 2only 3 parts and is very lightweight on the face. The AirFit N10 Spring Air™ cushion fits comfortably for an optimal seal.
When comfortable over the nose, pop the headgear over the head. Make sure the bottom strap comes under the ears. Use the magnets to join to frame and then use the Velcro to tighten the straps at the top and bottom of the headgear.
To take off the mask, disconnect the magnets at the bottom and pull over head.
Holding the top of the mask and frame, squeeze the tab and pull the seal away from mask frame.
Remove headgear by disconnecting the Velcro on top and sliding the headgear from the frame
Please Contact us for more information about CPAP masks and parts.